Limits given by the system

Below values are applicable to all flight modes:

LIMIT	VALUE
MAX forward speed	10 m/s
MAX ascend rate	3.5 m/s
MAX descend rate	1.5 m/s
MIN turn radius	3 m
MAX flight heigh	< 120 m
MAX roll angle in pitch/roll	40 degrees
Max turn acceleration turn in pitch/roll	20,000deg / s2
Yaw turn acceleration	7,000deg / s2

Limits given by the environment

LIMIT	VALUE
constant wind	< 10 m/s
gusts of wind	< 14m/s
MIN temperature	-20 degrees C
MAX temperature	50 degrees C

Limits given by the altitude

As altitude increases, the air density decreases. This affects the drone's performance as follows:

• The drone must spin faster to generate the same lift.
• More current is drawn, which results in reduced flight autonomy.

Safe Operating Limits

In MTOM configuration, this drone can safely operate up to:

5000 meters of altitude

At this altitude, the drone can:

• Lift its own weight
• Maneuver effectively within safe throttle levels

i

Altitude does not impose any limitations on the storage or transport of the drone.

Limits of operation by temperature

The drone is equipped with an internal heater for all electronics and a sealed structure that allows operation in extreme temperature conditions: -20°C to 50°C

Battery Performance at Low Temperatures

While the drone can operate in low temperatures, the batteries are more sensitive to cold. Battery performance can vary significantly at temperatures below 0°C.

i

Recommendations for Cold Weather Operations:

• Store batteries properly before the flight.
• Keep them at a temperature between 10°C and 20°C before use.

By following these guidelines, the drone will maintain optimal performance even in challenging temperature conditions.

Limits of operation by humidity

The drone can operate in high humidity conditions without restrictions. However, extra caution is required during post-operation storage.

i

Important Precautions for High Humidity (> 95%)

When operating in environments with ambient humidity above 95%, ensure the following steps are performed after the flight:

1. Dry all exposed connectors:

   • Battery connectors
   • I/O port connectors
   • Power source connectors (located at the bottom plate)

2. Inspect the drone for any signs of moisture accumulation.

By following these precautions, you can prevent potential damage caused by residual moisture and ensure the drone's longevity and reliability.

Limits given by the surroundings of the landing zone

i

Don’t operate within a 500m radius close to human infrastructure assets such voltage electro duct, tall buildings, high power radars, TV broadcasting emitters, among others.